I’ve installed the Sentry software but I still can change the time…

          Check to be sure that:

1. Sentry software has been started

2. Clock Locking is turned on in the software (see Sentry Administration)

3. The software was restarted after turning on locking the first time (the green Clock Locking light should be visible on the main screen)

How can I tell if Sentry is working?

If Sentry is not visible on the desktop, check the system tray for the hidden Sentry icon. (see Sentry Administration)

How can I tell if someone tried to change the clock?

The Sentry event log has a record of every time change on the computer (see Sentry Administration)

Can I get Sentry to start every time this computer starts?

You can configure Sentry for automatic start-up that will start Sentry every time the computer is on (and you are logged in) . Under Windows NT/2k/XP/2003 you can enable the ClockWatch service to run whenever Windows is up.

The time on the computer is wrong, how do I change it?

You can either sync to the Atomic Clock using Sentry or stop un lock the clock and use the Windows control panel (see Sentry Administration)